| |
TM 10-3930-669-34
8-2. TRANSMISSION VALVE BODY REPLACEMENT/REPAIR (CONT).
(7)
Install valve (39), spring (38), preformed packing
(37), and plug (36) in valve body (4). Tighten
plug to 25 to 35 lb-ft (34-47 Nm).
NOTE
Ensure small spring is aligned properly prior to installation.
(8)
Install seal (35) in valve body (4).
(9) Install accumulator control valve (33), spring (34), accumulator control valve (33), stop (32), spring (31), inching
valve (30), outer spring (29), inner spring (28), and inching valve plunger (27) in valve body (4).
NOTE
It may be necessary to push in on inching valve plunger slightly prior to installing inching valve
stop.
(10)
Install inching valve stop (26) in valve body (4).
(11)
Install pin (25) in valve body (4).
8-10
|