TM 10-3930-669-34 8-2.  TRANSMISSION VALVE BODY REPLACEMENT/REPAIR (CONT). CAUTION •  Do not allow any dirt or lint to enter transmission or valve body or damage to equipment can result. •  Do not use any kind of wiping rag around valve body of transmission where valve body mounts or damage to equipment can result. •  Allow  all  parts  to  air  dry.    Do  not  use  a  cloth  or  shop  towel.    Lint  can  get  into  transmission circuit. (3) Inspect valve body and valve surfaces for nicks, scratches, or burrs that can cause leaks. (4) Inspect springs for distortion, cracks, or deformation. (5) Inspect threaded parts for stripped or damaged threads or burrs. (6) Replace any parts that show obvious signs of damage. d.  Assembly. CAUTION Do  not  hammer  or  force  pins  or  stops.    They  should  fit  with  light  to  medium  hand  pressure. Hammering or forcing parts can result in severe damage to valve body. NOTE •  Place valve body on a clean, lint-free surface. •  Lightly lubricate preformed packings with transmission fluid prior to installation. (1) Install plug and wire assembly (55) in valve body (4). (2) Install  four  preformed  packings  (54)  and  plugs (53) in valve body (4). (3) Install three plugs (52) in valve body (4). 8-8