TM 10-3930-669-34 (9) Remove pin (45), plug (46), preformed packing (47), accumulator valve (48), stop (49), spring (50), and regulator valve (51) from valve body (4).  Discard preformed packing. (10) Remove  three  plugs  (52),  four  plugs  (53),  and preformed   packings   (54)   from   valve   body   (4) Discard preformed packings. (11) Remove plug and wire assembly (55) from valve body (4). c.  Cleaning/Inspection. WARNING • Dry-cleaning solvent (P-D-680) is TOXIC and flammable.  Wear protective goggles and gloves; use  only  in  a  well-ventilated  area;  avoid  contact  with  skin,  eyes,  and  clothes;  and  do  not breathe  vapors.    Keep  away  from  heat  or  flame.    Never  smoke  when  using  solvent;  the flashpoint for type I dry-cleaning solvent is 100'F (38'C) and for type II is 138'F (50°C).  Failure to do so may result in injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help.    If  solvent  contacts  skin  or  clothes,  flush  with  cold  water.    If  solvent  contacts  eyes, immediately flush eyes with water and get immediate medical attention. (1) Rinse all metal parts in dry-cleaning solvent to remove dirt, grease, and transmission oil. (2) Take special care to remove all dry-cleaning solvent from oil passages, grooves, and valve bores. 8-7