TM 10-3930-669-34 (4) Install   seal   (30)   and   fuel   supply   pump   (4)   on injection pump (17) with three lock washers (29) and nuts (28).  Tighten nuts to 7 lb-ft (10 N•m). (5)    Install  oil  line  (12)  on  injection  pump  (17)  with two seals (11) and screw (27). (6) Install key (26) in injection pump shaft (24). (7) Position gasket (25) on engine block (13). NOTE Prior    to    mounting    injection    pump, align groove in timing device with key on injection pump shaft. (8)    Mount injection pump (17) on engine block (13) by  inserting  shaft  (24)  and  key  (26)  in  timing device (19). (9)    Position   injection   pump   (17)   on   front   engine cover (21) with four washers (23) and nuts (22). (10)    Turn   injection   pump,   as   required,   until   four washers   (23)   and   nuts   (22)   are   centered   in elongated   holes   (37)   of   injection   pump   (17). Tighten nuts 36 lb-ft (49 N•m). 4-21