TM 10-3930-669-34 3-13. PISTON AND CONNECTING ROD ASSEMBLY REPLACEMENT/REPAIR. This task covers: a. Removal c. Inspection e. Installation b. Disassembly d. Assembly INITIAL SETUP Tools and Special Tools Materials Parts Tool Kit, General Mechanic’s: Automotive Lubricating Oil (Item 15, Appendix B) (Item 1, Appendix E) Rags, Wiping (Item 19, Appendix B) Gauge, Dial, Bore, Cylinder Solvent, Dry-cleaning (Item 5, Appendix E) (Item 20, Appendix B) Wrench, Torque (0-60 N.m) Washer, Lock (2) (Item 5, Appendix E) Washer, Lock (2) Heater (Item 5, Appendix E) Press, 60 Ton (Item 5, Appendix E) Equipment Condition Pliers, Snap ring (Item 5, Appendix E) Cylinders removed (Para 3-7) Gage, Tightening (Item 22, Appendix E) Oil pump removed (Para 3-12) a. Removal. NOTE • All   piston   and   connecting   rod assemblies     are     removed     the same way. Piston and connecting  rod  assembly  No.    4 is shown. • Do  not  miss  match  connecting rod bearing caps. (1) Remove   two   screws   (1)   and   connecting   rod bearing  cap  (2)  from  piston  and  connecting  rod assembly (3). (2) Remove   bearing   half   (4)   from   connecting   rod bearing cap (2). 3-66