| |
TM 10-3930-669-34
c.
Cleaning/lnspection.
WARNING
•
Dry-cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles
and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke
when using solvent; the flashpoint for type I dry-cleaning solvent is 100°F (38°C)
and for type II is 138°F (50°C). Failure to do so may result in injury or death to
personnel.
•
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If
solvent contacts eyes, immediately flush eyes with water and get immediate
medical attention.
•
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use
only
with
effective
chip
guarding
and
personal
protective
equipment
(goggles/shield, gloves, etc.). Failure to comply may result in injury or death to
personnel.
(1)
Clean all metal parts with dry-cleaning
solvent.
(2)
Inspect all parts for cracks or damage.
(3)
Replace all damaged parts.
d.
Assembly.
(1)
Install gasket (32) and plate (30) on front
cover (3) with three screws (31).
(2)
Install preformed packing (29), and two
studs (27 and 28) in front cover (3).
3-57
|
