| |
TM 10-3930-669-20
b. Cleaning/Inspection.
WARNING
·
Drycleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use
only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors.
Keep away from heat or flame. Never smoke when using solvent; the flashpoint for type I
drycleaning solvent is 100°F (38°C) and for type II is 138°F (50°C). Failure to do so may result in
injury or death to personnel.
·
If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help.
If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush
eyes with water and get immediate medical attention.
(1)
Clean all metal parts with drycleaning solvent.
(2)
Inspect all parts for breaks, cracks, burrs, and sharp edges.
(3)
Replace all damaged parts.
c. Installation.
(1)
Install steering wheel (6) on steering shaft (4)
with nut (5). Tighten nut 30 to 41 lb-ft (40-55
N•m).
(2)
Install ground wire (3) on steering shaft (4) with
washer (2) and screw (1).
NOTE
Follow-on Maintenance:
·
Install horn button (Para 7-46).
·
Close cab door (TM 10-3930-669-10).
·
Connect batteries (Para 7-48).
·
Remove wheel chocks (TM 10-3930-669-10).
END OF TASK
13-9
|
