| |
TM 10-3930-669-20
(2)
Installation.
(a)
With the aid of an assistant, position rear
wheel (3) on rear axle assembly (6).
(b)
Install five nuts (4) on studs (5).
(c)
Remove wooden blocks from under frame
of forklift (1).
(d)
Lower floor jack slowly until rear wheels
(3) are in contact with the ground. Do not
put full weight of the forklift on the ground.
NOTE
If wheels spins while
tightening nuts, lower
jack slightly. Do not
put full weight of forklift
on ground.
(e)
Tighten nuts (4) to 185 to 240 Ib-ft (251-
325 N.m) as shown in the tightening
sequence pattern.
(f)
Remove floor jack from under
counterweight (2).
NOTE
Follow-on Maintenance:
·
Remove wheel chocks (TM 10-3930-669-10).
END OF TASK
12-5/(12-6 blank)
|
