TM 10-3930-669-20 11-3.  PARKING BRAKE CABLE REPLACEMENT/ADJUSTMENT (CONT). c.  Installation. (1)   Place parking brake cable (2) in forklift cab frame (18). (2)   Adjust top of nut (3) 0.75 in. (19.05 mm) from top thread of cable (2). (3)   Install clevis (10) on parking brake handle assembly (1) with four washers (9), pin (8), washer (7), and retaining pin (6). (4)   Place parking brake cable (2) in cab frame bracket (5) and tighten nut (4). (5)   Place 0.031 in.  (0.794 mm) shim between rotor (19) and front brake pad (20). (6)   Place parking brake cable (2) in bracket (13). (7)   Install parking brake cable (2) on brake lever (17) with pin (16), washer (15), and retaining pin (14). (8)   Gently remove slack in cable (2) by hand tightening nut (11).  Tighten nut (12). (9)   Remove shim. 11-8