| |
TM 10-3930-669-20
(4)
Coat preformed packing (2) with a light coat of
clean transmission oil.
(5)
Install preformed packing (2) and drain plug (1)
in drain plate (3).
(6)
Remove dipstick (7) from transmission dipstick
tube (8) and wipe with clean wiping rag.
(7)
Fill transmission with 7 qt (7 l) of transmission
oil in dipstick tube (8).
CAUTION
Check dipstick for dirt or other
contamination before installing in
dipstick
tube.
Wipe
any
contamination away using a clean
wiping rag or damage to equipment
may result.
(8)
Insert dipstick (7) in dipstick tube (8).
(9)
Start engine (TM 10-3930-669-10) and run for
five minutes.
(10) With engine running and transmission in neutral, remove dipstick (7) from transmission dipstick tube (8) and
check oil level.
(11) Add transmission oil as necessary (LO 10-3930-669-12) until oil level is at the FULL mark (9) on dipstick (7).
(12) Stop engine (TM 10-3930-669-10).
NOTE
Follow-on Maintenance:
•
Close cab engine access door (TM 10-3930-669-10).
•
Close cab door (TM 10-3930-669-10).
•
Remove wheel chocks (TM 10-3930-669-10).
END OF TASK
8-5
|
