| |
TM 10-3930-669-20
WARNING
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry contacts battery
terminal, a direct short may result in instant
heating of tools, damage to equipment, and
injury or death to personnel.
VOLTAGE TEST
(1) Remove relay R3 (Para 7-33).
(2) Set multimeter select switch to
VOLTS DC.
(3) Connect positive (+) multimeter
lead to relay R3, terminal 30
cavity.
(4) Connect negative (-) multimeter
lead to a known good ground.
(5) Start engine (TM 10-3930-669-10).
(a) If there are not 22 to 24 vdc
present, perform Step (6) below
and repair wire 33 (see
schematic Appendix F).
(b) If there are 22 to 24 vdc
present, wire 33 is OK.
(6) Shut down engine.
(7) Install relay R3 (Para 7-33)
(8) Install upper and lower column
covers (Para 7-21).
VOLTAGE TEST
(1) Remove relay R5 (Para 7-33).
(2) Set multimeter select switch to
OHMS.
(3) Check continuity between relay R3,
terminal 87 and relay R5, terminal
86 cavities.
(a) If there is no continuity, repair
wire 32 (see schematic
Appendix F).
(b) If there is continuity, replace
relay R3.
(4) Install relays R5 and R3.
2-31
|