TM 10-3930-669-20 (2) Position   alternator   (18)   on   engine   (19) with   screw   (16)   and   nut   (15).      Do   not tighten. (3) Move  alternator  (18)  toward  engine  (19) and place belt (20) on pulley (21). (4) Move   alternator   (18)   away   from   engine (19) until tension is on belt (20). (5) Install  flat  washer  (23),  lock  washer  (22), and screw (17) on alternator (18). Tighten to 18 lb-ft (25 N.m). (6) Tighten  nut  (15)  on  screw  (16)  to  36  lb-ft (49 N.m). (7) Install  ground  strap  (13)  on  terminal  (14) with washer (12) and nut (11). (8) Install  wire  (9)  on  terminal  (10)  with  nut (8). (9) Install  wire  (6)  on  terminal  (7)  with  lock screw (5). (10) Connect     alternator     connector     (4)     on connector (3). (11) Install  connector  (1)  on  voltage  regulator (2). NOTE Follow-on Maintenance: • Connect batteries (Para 7-48) • Adjust alternator belt (Para 7-3). • Install drive axle oil cooler assembly (Para 10-2). • Remove wheel chocks (TM 10-3930-669-10). END OF TASK 7-5