| |
TM 10-3930-669-20
6-6. BLOWER BELT TENSIONER REPLACEMENT (CONT).
(3)
Inspect switch and wires for damage, cracks,
burrs, and sharp edges.
(4)
Replace all damaged parts.
c. Installation.
(1)
Place preformed packing (23) on broken belt
tensioner (18).
(2)
Install preformed packing (23) and broken belt
tensioner (18) on engine (11) with washer (22)
and screw (21).
Tighten nut to 18 lb-ft (25 Nm).
(3)
Apply sealing compound to screw (19).
(4)
Install screw (19) and washer (20) on blower belt
tensioner (18).
(5)
Install blower belt tensioner pulley (4) on blower
belt tensioner (18) with screw (12), two washers
(17 and 16), washer (15), and nut (14). Tighten
nut to 18 lb-ft (25 Nm).
WARNING
Blower belt tensioner is under spring
tension and could cause injury.
(6)
Using a wrench on screw (12) turn blower belt
tensioner pulley (4) towards the right and install
belt (13). Slowly release tension.
6-16
|