TM 10-3930-669-20 2-32.  STORAGE MAINTENANCE PROCEDURES (CONT.) . f. Tilt the mast assembly forward to collapse both tilt cylinders. g. Position the sideshift front end to the right side of the forklift.  One shift cylinder will collapse with the second extended. h. Remove batteries (Para 7-48). (1) Brush and clean battery cable terminal ends if corrosion is present.  Coat with a thin coat of grease. CAUTION Do not place battery on concrete floor; use wood as an insulator.  Failure to comply may result in damage to the battery. (2) Place battery where it may be periodically serviced and charged. i. Perform complete lubrication in accordance with LO 10-3930-669-12. WARNING • Drycleaning   solvent   (P-D-680)   is   TOXIC   and   flammable.      Wear   protective   goggles   and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors.  Keep away from heat or flame.  Never smoke when using solvent; the flashpoint  for  type  I  drycleaning  solvent  is  100°F  (38°C)  and  for  type  II  is  138°F  (50°C). Failure to do so may result in injury or death to personnel. • If  personnel  become  dizzy  while  using  cleaning  solvent,  immediately  get  fresh  air  and medical help.  If solvent contacts skin or clothes, flush with cold water.  If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. j. Clean off the lubricating grease from exposed metal side shift channels or guides using drycleaning solvent (P-D-680).  Spray all exposed side shift surfaces with a long-term corrosion inhibitor. k. Protect the exposed shift cylinder rod and chains by spraying corrosion inhibitor. I. Protect mast assembly chains, carriage tips, and any other exposed metal parts by spraying with corrosion inhibitor. 2-496