TM 10-3930-669-20 Section II.  SERVICE UPON RECEIPT 2-4.   GENERAL SERVICE INSTRUCTIONS. a. Refer to TM 10-3930-669-10 for operating instructions for the forklift. b. Upon receipt of a new, used, or reconditioned forklift, the receiving organization must see if it has been properly prepared   for   service   and   is   in   good   condition   (TM   10-3930-669-10).      Inspect   all   assemblies,   subassemblies,   and accessories to be sure they are in proper working order.  Secure, clean, correctly adjust, and/or lubricate (LO 10-3930- 669-12) as needed. c. Follow general procedures for all services and inspections given in TM 10-3930-669-10 . 2-5.   INSPECTION AND SERVICING EQUIPMENT. NOTE If  forklift  has  been  driven  to  the  using  organization,  most  or  all  of  the  following  work should have been done. a. When  forklift  is  received,  inspect  all  items  for  damage  that  may  have  occurred  during  shipping  and  unloading operations.  Pay close attention to any loose or missing nuts, bolts, screws, access plates, drain plugs, draincocks, oil plugs, assemblies, subassemblies, or components that may have been lost or broken in transit. WARNING •   Drycleaning  solvent  (P-D-680)  is  TOXIC  and  flammable.    Wear  protective  goggles  and gloves;  use  only  in  a  well-ventilated  area;  avoid  contact  with  skin,  eyes,  and  clothes; and  do  not  breathe  vapors.   Keep  away  from  heat  or  flame.   Never  smoke  when  using solvent;  the  flashpoint  for  type  I  drycleaning  solvent  is  100°F  (38°C)  and  for  type  II  is 138°F (50°C).  Failure to do so may result in injury or death to personnel. •   If  personnel  become  dizzy  while  using  cleaning  solvent,  immediately  get  fresh  air  and medical  help.    If  solvent  contacts  skin  or  clothes,  flush  with  cold  water.    If  solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. b. Clean all exterior surfaces coated with rust-preventive compound with drycleaning solvent. c. Lubricate  specific  points  shown  in  LO  10-3930-669-12  regardless  of  interval.    Do  not  lubricate  gear  cases  or engine.    Check  processing  tag  for  gear  case  and  engine  oil.    If  tag  states  the  oil  is  good  for  500  miles  (805  km)  of operation and is of the proper grade for local climatic operation, check oil level but do not change oil. 2-3