| |
PRESSURE TEST AND STEFICE-R #10
(1)
Remove cap from tachometer drive.
(2)
Install
pulse
tachometer
on
tachometer drive.
(3)
Remove floor plate (Para 15-12).
(4)
Remove plug from transmission.
(5)
Start engine (TM 10-3930-669-10).
(6)
Observe VTM for results.
(a) If 625 to 750 rpm is not displayed,
perform Steps (7) and (8) below
and adjust engine idle speed
(Para 4-7).
(b) If 625 to 750 rpm is displayed,
perform Steps (7) through (9)
below, engine idle is OK.
(7)
Shut down engine.
(8)
Remove
pulse
tachometer
from
tachometer drive.
(9)
Install cap on tachometer drive.
VISUAL INSPECTION
(1)
Start engine (TM 10-3930-669-10).
(2)
Set transmission control lever to
forward position (TM 10-3930-669-
10).
(3)
While
observing
transmission
temperature gauge, operate forklift for
10 to 15 minutes.
(a) If transmission oil temperature
does not exceed 230°F (110°C),
perform Steps (4) and (5) below
and go to Step 4 of this Fault.
(b) If transmission oil temperature
exceeds 230°F (110°C), perform
Step (6) below and notify DS
Maintenance.
(4)
Apply parking brake.
(5)
Set transmission control lever to
neutral position.
(6)
Shut down engine.
2-325
|