TM 10-3930-669-20 WARNING Remove all jewelry such as rings, dog tags.  bracelets, etc.  If jewelry contacts battery terminal, a direct short may result in instant heating of tools, damage to equipment.  and injury or death to personnel. NOTE If test Error occurs, refer to Appendix J, TM 9-4910-571-12&P. STE/ICE-R #73 AND 75 TEST (1)   Disconnect    connector    P10    from    fuel solenoid connector (Para 7-36). (2)   Perform  Confidence  Test  (TM  9-4910- 571-12&P). (3)   Set     MAIN     POWER     switch     to     ON position (TM 10-3930-669-10). (4)   Set  engine  switch  to  start  position  until OFF is displayed on VTM. (a)   If   between   13   milliohms   or   below are not displayed, perform Steps (5) through     (8)     below     and     replace battery (Para 7-48). (b)   If 13 milliohms or below are displayed, go to Step (5) below. (5)   Set engine switch to off position (TM 10- 3930-669-10). (6)   Set  engine  switch  to  start  position  until OFF is displayed on VTM. (a)   If 50 milliohms/sec or below are not displayed.    perform  Steps  (7)  and (8) below and replace battery (Para 7-47). (b)   If   50   milliohms/sec   or   below   are displayed, battery is OK. (7)   Set    MAIN    POWER    switch    to    OFF position. (8)   Connect  connector  P10  to  fuel  shutoff solenoid connector. 2-283