| |
TM 10-3930-669-20
VOLTAGE TEST
(1) Remove floor plate (Para 15-12).
(2) Disconnect
connector
P11
from
transmission control connector.
(3) Set multimeter select switch to VOLTS
DC.
(4) Connect positive (+) multimeter lead to
transmission control connector, terminal
1.
(5) Connect negative (-) multimeter lead to
a known good ground.
(6) Set MAIN POWER switch to ON
position (TM 10-3930669-10).
(7) Set engine switch to ignition position
(TM 10-3930-669-10).
(8) Set transmission range switch to HIGH
RANGE position (TM 10-3930-669-10).
(a) If there are not 22 to 24 vdc 7
present, high range solenoid faulty.
Perform Steps (9) and (10) below
and notify DS Maintenance.
(b) If there are 22 to 24 vdc present,
repair
wire
14
(see
schematic
Appendix F).
(9) Connect connector P11 on transmission
control connector.
(10) Install floor plate (TM 10-3930-669-10).
2-271
|
