TM 10-3930-669-20 WARNING Remove all jewelry such as rings, dog tags, bracelets, etc.  If jewelry contacts battery terminal, a direct short may result in instant heating of tools, damage to equipment, and injury or death to personnel. CONTINUITY TEST (1)   Set multimeter select switch to OHMS. (2)   Check    continuity    across    belt    sensor connector, terminals 1 and 4. (a)   If there is no continuity, replace belt sensor (Para 7-40). (b)   If  there  is  continuity,  belt  sensor  is OK. (3)   Connect  connector  P15  on  belt  sensor connector. (4)   Install engine ventilation panel (Para 6- 2). 2-247