| |
TM 10-3930-669-20
WARNING
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts battery terminal, a
direct short may result in instant heating of tools, damage to equipment, and injury or death to
personnel.
VOLTAGE TEST
(1)
Open engine access panel
(TM 10-3930-669-10).
(2)
Set multimeter select switch to
VOLTS DC.
(3)
Connect positive (+) multimeter lead
to glow plug.
(4)
Connect negative (-) multimeter
lead to a known good ground.
(5)
Set MAIN POWER switch to ON
position (TM 10-3930-669-10).
(6)
Set engine switch to ignition
position (TM 10-3930-669-10).
(7)
Depress glow plug switch
(TM 10-3930-669-10).
(a)
If there are not 22 to 24 vdc
present, perform Steps (8)
through (10) below and go to
Step 5 of this Fault.
(b)
If there are 22 to 24 vdc present,
perform Steps (8) through (10)
below and go to Step 3 of this
Fault.
(8)
Set engine switch to off position.
(9)
Set MAIN POWER switch to OFF
position.
(10)
Close engine access panel.
2-231
|
