| |
TM 10-3930-669-20
CONTINUITY TEST
(1) Remove floor plate (Para 15-12).
(2) Set multimeter select switch to OHMS.
(3) Ground
wire
15
at
transmission
temperature sensor.
(4) Check continuity between transmission
temperature gauge, terminal S and a
known good ground.
(a) If there is no continuity, repair wire
15 (see schematic Appendix F).
(b) If
there
is
continuity
replace
transmission
temperature
gauge
(Para 7-9) and go to Step 5 of this
Fault.
(5) Install instrument panel (Para 7-8).
VERIFY REPAIR
(1) Start engine (TM 10-3930-669-10).
(2) Observe
transmission
temperature
gauge.
(a) If gauge does not give correct
reading,
fault
not
corrected.
Perform Step (3) below. Repeat
procedure and notify Supervisor.
(b) If gauge gives correct reading, fault
corrected.
(3) Shut down engine.
2-149
|
