| |
TM 10-3930-669-20
17-6. TILT CYLINDER REPLACEMENT/ADJUSTMENT.
This task covers:
a. Removal
b. Installation
c. Adjustment
INITIAL SETUP
Tools and Special Tools
Tool Kit, General Mechanic's: Automotive (Item 1,
Appendix B)
Wrench, Torque (0 to 175 lb-ft [0-237 N•m]) (Item 2,
Appendix B)
Leveling, Devices (Item 2, Appendix B)
Materials/Parts
Cap and Plug Set (Item 5, Appendix C)
Tags, Identification (Item 21, Appendix C)
Packing, Preformed (2)
Washer, Lock (2)
a. Removal.
WARNING
High-pressure hydraulics operate
this equipment. Never disconnect
any hydraulic line or fitting without
first dropping pressure to zero. A
high-pressure oil stream can pierce
body and cause severe injury to
personnel.
NOTE
·
Both tilt cylinders are removed
the same way. Left side is
shown.
·
Cap and plug all hydraulic hoses
after removal.
·
Tag and mark all hoses after
removal.
(1)
Loosen two fittings (1) and remove oil lines (2)
from elbows (3 and 4).
Equipment Condition
Engine OFF (TM 10-3930-669-10)
Parking brake applied (TM 10-3930-669-10)
Wheels chocked (TM 10-3930-669-10)
Mast pivoted 90° (TM 10-3930-669-10)
17-23
|
