| |
TM 10-3930-669-20
(6)
Position housing (23) on tilt/lift joystick (15) and
install six screws (22), twelve washers (21), six
lock washers (20), and nuts (19). Tighten nuts
to 8 lb-ft (11 N•m).
NOTE
·
Do not tighten nuts on cables of
tilt/lift joystick until they are
adjusted during installation.
·
Tilt control valve cable assembly
is shown. Lift Shift control valve
cable is assembled the same
way.
(7)
Position two nuts (1) and lock washer (18) on lift
control valve cable (4) of tilt/lift joystick (15).
(8)
Position bracket (2) and nut (17) on lift control
valve cable (4) of tilt/lift joystick (15).
e. Installation.
(1)
Install tilt/lift joystick (15) on dash frame (16)
with four washers (14), lock washers (13), and
screws (12). Tighten screws to 7 lb-ft (10 N•m).
17-17
|
