TM 10-3930-669-10 2-10.  OPERATING PROCEDURES (CONT). NOTE • The  load  face  nearest  the  operator  should  be  very  close  to  the  vertical  rack  member  and  in view of the operator. • You  will  notice  mast  assembly  counterclockwise  pivot  and  left-hand  shift  action  at  the  same time.  These functions will not be synchronized and one function may stop before the other. (8) Shift the loaded mast assembly to the left until the load is more than halfway out.  When the load is more than halfway out, begin moving in reverse at a slow (creep) speed and pull the mast assembly pivot/shift joystick (Table 2-1, 16) rearward and to the left. (9) When the load is partially shifted to the left and at an angle of approximately 45 degrees, stop the left-hand shifting motion. (10) With the forklift still moving in reverse at a slow (creep) speed, continue to pivot the load counterclockwise until the far corner of the load is clear of the opening.  Continue to pivot load while shifting mast assembly back to the right until load is centered in front of the truck. (11) Lower  the  load  to  approximately  12  inches  (305  mm)  above  the  ground.    Refer  to  Step  e.    for  driving procedures. 2-32