EXPLANATION OF COLUMNS (SECTION IV) - TM-10-3930-668-24P0010

TM 10-3930-668-24P

EXPLANATION OF COLUMNS (SECTION II) (CONT).

(4)

The statement 'END OF FIGURES appears just below the last item description in Column 5 for a given

QTY (Column(6)). The QTY (quantity per figure column) indicates the quantity of the item used the

breakout shown on the illustration figure, which is prepared for a functional group, sub functional group, or an assembly.

A 'V appearing in this column in lieu of a quantity indicates that the quantity is variable and the quantity may vary from

application to application.

EXPLANATION OF COLUMNS (SECTION IV).

National Stock Number (NSN) Index.

(1)

Stock Number column. This column lists the NSN by National Item Identification Number (NIIN)

sequence. The NIIN consists of the last nine digits of the NSN, i.e.

NSN

NSN i.e.

(5305-01-574-1467)

NIIN

When using this column to locate an item, ignore the first 4 digits of the NSN. However, the complete NSN should be

used when ordering items by stock number.

(2)

FIG. column. This column lists the number of the figure where the item is identified/located. The

figures are in numerical order in Section II.

(3)

ITEM column. The item number identifies the item associated with the figure listed in the adjacent

FIG. column. This item is also identified by the NSN listed on the same line.

b. Part Number Index. Part numbers in this index are listed by part number in ascending alphanumeric

sequence (i.e., vertical arrangement of letter and number combinations which places the first letter or digit of each group

in order A thorough Z, followed by the number 0 through 9 and each following letter or digit in like order).

(1)

CAGE column. The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric code

used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.

(2)

PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,

corporation, or Government activity), which controls the design and characteristics of the item by

means of its engineering drawings, specifications and inspection requirements to identify and item or

range of items.

(3)

STOCK NUMBER column. This column lists the NSN for the associated part number and

manufacturer identified in the PART NUMBER and CAGEC columns to the left.

(4)

FIG. column. This column lists the number of the figure where the item is identified/located in

Sections II and III.

(5)

ITEM column. This item number is that number assigned to the item as it appears in the figure

referenced in the adjacent figure number column.

Figure end Item Number Index.

(1)

FIG. column. This column lists the number of the figure where the item is identified/located in

Sections II and III.