TM 10-3930-664-24 Section VII.  DISC BRAKE ASSEMBLY MAINTENANCE 4-36.  DISC BRAKE ASSEMBLY REPLACEMENT This task covers: Removal, Cleaning, Inspection, and Installation INITIAL SETUP: Tools and Test Equipment: Equipment Condition: General Mechanics Tool Kit (1, App.  E) Wheel assembly removed Torque Wrench (32, App.  E) (para.  2-113) Torque Wrench (34, App.  E) Front axle servicing, drain Air Compressor Unit (16, App.  E) (para.  2-102) 3/4" Drive Socket Set (55, App.  E) Rear axle servicing, drain Drain Pan (10, App.  E) (para.  2-104) Puller, Tie Rod (56, App.  E) Materials / Parts: Personnel Required: Loctite No.  242 (20, App.  C) 2 personnel Cotter Pin, Item 3 (2 ea.) Seal, Item 16 (1 ea.) Seal, Item 18 (1 ea.) Packing, Item 21 (1 ea.) Packing, Item 25 (3 ea.) A.  REMOVAL NOTE These  procedures  are  used  for  both the   front   and   rear   axle   assemblies. Perform  steps  5,  6,  7,  and  8  only  on the front axle assembly. 1. Remove and discard cotter pin (3).  Remove tie rod (1)  from  steering  case  (2)  by  removing  nut  (4)  and separating tie rod using a puller. 2. It   is   not   necessary   to   remove   tie   rod   (1)   from steering    cylinder    (5).        Remove    tie    rod    only    if replacement is required. 4-100