| |
TM 10-3930-664-24
7.
Insert three planet gears (12) into carrier (3).
8.
Install bearings (9) and spacers (10) onto pins (8).
Install new O-rings (7).
9.
Position friction washers (11) under planet gears
(12), ensuring that washers are aligned with holes in
planet gears and gear carriers. Tab must be on
inside of gear carrier ring.
10.
Press assembled pins (8) and bearings (9) into
carrier (3). Tap into place using a soft head
hammer.
11.
Install new circlip (6) into groove at rear of carrier
(3).
12.
Carefully install carrier (3) onto wheel hub (5).
Secure using three bolts (4).
13.
Install wheel assembly (para. 2-113).
14.
Position fill/drain port at center of axle. Service
planetary gear carrier with fresh oil. Install plug (1)
and new seal washer (2).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
4-95
|
