TM 10-3930-664-24 NOTE For  ease  of  assembly,  note  number and    size    of    shims    (14,    16)    when removing. 5. Remove cover plate (10), seal (11), and spacer (12), inner  race  of  bearing  (13),  shim  (14),  and  spacer (15) from differential housing (9). 6. Remove shims (16) from bevel gear shaft (18). 7. Using an  arbor  press,  remove  inner  race  of  bearing (17) from bevel gear shaft (18). 8. Remove    outer    races    of    bearings    (13,    17)    from cavities in differential housing. B.  CLEANING Clean    bevel    gear    components    in    accordance    with paragraph 1-24. C.  INSPECTION     Inspect    bevel    gear    components    in    accordance    with paragraph 1-24. D.  INSTALLATION    1. Install    shims    (16)    into    front    bearing    cavity    on differential housing (9).  Press outer race of bearing (17) into cavity. 2. Press  outer  race  of  bearing  (13)  into  rear  bearing cavity in differential housing (9). 3. Press   inner   race   of   bearing   (17)   onto   bevel   gear shaft (18). 4. Install   spacer   (15),   shims   (14),   and   inner   race   of bearing (13) into differential housing (9). 5. Support   bearing   (13)   with   tube   stock   of   suitable inside  diameter.    Press  bevel  gear  shaft  (18)  with bearing (17) into differential housing (9). 6. Install  spacer  (12),  seal  (11),  cover  plate  (10),  and flange (9) onto bevel gear shaft (18). 4-75