| |
TM 10-3930-664-24
4.
Remove outer thrust washer (6), bearing (7), and
inner thrust washer (8) from shaft (2).
5.
Using pliers, remove snap ring (9) from ring groove.
6.
Remove clutch end plate (10), five inner discs (11),
and five outer discs (12) from shaft (2).
8.
Compress disc washers (13) and remove snap ring
(14) using pliers. Remove retainer (15).
NOTE
Disc washers are installed as a set.
Do not intermix with sets from other
clutches. Replace disc washers as a
set.
9.
Remove five disc washers (13) and wear plate (16)
from shaft (2).
10. Turn clutch over and tap shaft (2) with a soft head
hammer to remove clutch piston (17).
11. Remove and discard seals (18, 19).
B. CLEANING
Clean third clutch gear components in accordance with
paragraph 1-24.
C. INSPECTION
1.
Inspect third clutch gear components in accordance
with paragraph 1-24.
2.
Ensure two bleed valves in clutch drum are clean
and free of foreign material.
4-67
|
