| |
TM 10-3930-664-24
5.
Remove gear and bearing assembly (12), outer
thrust washer (13), bearing (14), and inner thrust
washer (15) from shaft (27).
6.
Using pliers, remove snap ring (16) from ring
groove.
7.
Remove clutch end plate (17), ten inner discs
(18), and ten outer discs (19) from shaft (27).
8.
Compress disc washers (22) and remove snap
ring (20) using pliers. Remove retainer (21).
NOTE
Disc washers are installed as a set. Do
not
intermix
with
sets
from
other
clutches. Replace disc washers as a
set.
9.
Remove seven disc washers (22) and wear plate
(23) from shaft (27).
10.
Turn clutch over and tap shaft (27) with a soft
head hammer to remove clutch piston (24).
11.
Remove and discard seals (25, 26).
4-54
|
