| |
TM 10-3930-664-24
9.
Remove screw (19) and washer (20) from
reverse idler gear shaft (26). Remove end plate
(21) from pin (26).
10.
Remove reverse idler gear (22) and bearing (23)
from idler gear shaft (26).
11.
To remove idler gear shaft (26), support spacer
plate (6) around idler gear shaft opening. Press
idler gear shaft from spacer plate and remove
thrust washer (25). Remove locator ring.
12.
Remove retaining ring (27) from convertor end of
stator gearshaft (28).
13.
Push stator gearshaft (28) towards transmission
side of spacer plate (6) to expose retaining ring
(29). Remove retaining ring.
14.
Remove stator gearshaft (28) and thrust washer
(30) from spacer plate (6).
15.
Remove piston rings (31, 32) from stator
gearshaft (28) and discard.
16.
Remove bearing (33) and bushing (34) from
stator gearshaft (28) only if replacement is
required.
B. CLEANING
Clean spacer plate, gears, and related components
in accordance with paragraph 1-24.
C. INSPECTION
Inspect
spacer
plate,
gears,
shafts,
and
related
components in accordance with paragraph 1-24.
4-43
|
