TM 10-3930-664-24 NOTE Rear   bearing   block   face   should   sit just below back face of gear housing (3).    If  bearing  block  sits  higher  than housing   face,   remove   gear   housing and check that E-seals, backup rings, or O-rings did not shift during assembly. 11. If  removed,  insert  dowel  pins  into  gear  housing (3). 12. Mate  end  cover  (2)  to  gear  housing  (3).    Install four bolts (1) and torque to 56 ft-lbs (77 Nm). 13. Place a small amount of oil into pump inlet port. Rotate  driveshaft  away  from  inlet  port  one  full revolution.  If  driveshaft  binds,  disassemble  and reassemble pump. FOLLOW-ON MAINTENANCE: Install hydraulic pump (para.  2-147) END OF TASK 3-205