| |
TM 10-3930-664-24
5.
REMOVE RUBBER SEAL (34) FROM PANEL
WELDMENT (35).REMOVE INSULATION (40)
ONLY IF REPLACEMENT IS REQUIRED.
6.
REMOVE
ANGLE
BRACKET
(36)
FROM
PANEL
WELDMENT
(35)
BY
REMOVING
SCREWS
(37),
WASHERS
(38),
AND
LOCKNUTS (39).
B. CLEANING
Clean cab assembly components in accordance with
paragraph 1-24.
C. INSPECTION
1.
Conduct overall inspection of cab assembly
components in accordance with paragraph 1-24.
2.
Inspect
rubber
seals
for
cracking,
tears,
discoloration, or deformation.
D. REPAIR
1.
Repair of the cab assembly consists of removal
and replacement of defective, deformed, or
damaged components.
2.
Repair cab assembly sheet metal in accordance
with TC 9-510.
E. ASSEMBLY
1.
INSTALL ANGLE BRACKET (36) ONTO PANEL
WELDMENT
(35)
USING
SCREWS
(37),
WASHERS (38), AND LOCKNUTS (39).
2.
INSTALL RUBBER SEAL (34) ONTO PANEL
WELDMENT (35). INSTALL INSULATION (40).
3.
INSTALL RIGHT WINDOW SLIDE (26) ONTO
WINDOW FRAME (25).
a.
Secure right window slide (26) to window
frame (25) using screw (27), lockwasher
(28), and washer (29).
b.
Install knob (30), washers (31, 32), and
bracket (33) onto right window slide (26).
3-177
|
