TM 10-3930-664-24 2. REMOVE BUMPER (7), SEAL PLATE (10), AND STRIKER   (13)   FROM   DRIVER   SIDE   PANEL WELDMENT (8). a. Remove   rubber   bumper   (7)   from   panel weldment (8) by removing nut (9). b. Remove seal plate (10) from base of panel weldment   (8)   by   removing   four   screws (11).  Remove rubber seal (12). c. Remove  striker  (13)  from  panel  weldment (8) by removing nut (14). d. Remove    rubber    seal    (24)    from    panel weldment (8). 3. REMOVE   LATCH   LEVER   (22)   FROM   PANEL WELDMENT (8). a. Remove   screws   (15),   backup   seal   (16), and   door   release   seal   (18)   from   panel weldment (8). b. Inspect  rivnuts  (17)  for  crossed,  stripped, or  damage  threads.    Replace  rivnuts  only if required. c. Remove spring (19) from lever (22). d. Remove   screw   (20)   and   nut   (21)   from lever (22).  Remove plastic grip (23) only if replacement is required. 4. REMOVE  RIGHT  WINDOW  SLIDE  (26)  FROM WINDOW FRAME (25). a. Remove    right    window    slide    (26)    from window   frame   (25)   by   removing   screw (27), lockwasher (28), and washer (29). b. Remove knob (30), washers (31, 32), and bracket (33) from right window slide (26). 3-176