TM 10-3930-664-24 5. Remove  thrust  washer  (8),  idler  gear  (9),  and gear bearing (10) from idler shaft (11). 6. Remove  idler  shaft  (11)  and  thrust  washer  (13) from converter housing (5).  Remove pin (12). 7. Remove   bearing   (14)   from   converter   housing (5). 9. Remove O-rings (15, 17), oil distributor ring (16), and oil seal (18).  Discard O-rings. 10. Remove  four  plugs  (19)  from  converter  housing (5).  Remove setscrews (20). 11. Using   a   bearing   puller,   remove   oil   distributor sleeves (21, 22) from converter housing (5). B.  CLEANING Clean converter housing and components in accordance with paragraph 1-24. C.  INSPECTION Inspect converter housing and components in accordance with paragraph 1-24. 3-107