TM 10-3930-664-24 2. Attach lifting chain to top of transmission (100) as follows: a. Install 1/2 inch washer (106) onto 12mm x 3.0 bolt (107). Insert bolt through chain link of lifting chain. Install nut (108) onto bolt. b. Install bolt (107) into hole at top of transmission (100), to the right of the oil filter. Thread bolt completely into hole then tighten nut (108). c. Attach lifting chain to hoist using shackle. 3. Raise hoist to take up slack in chains. Readjust chains as required. Move transmission (100) into place for assembly to engine (101). 4. If required, manually rotate engine flywheel by turning crankshaft pulley until drive plate mounting hole is aligned with flywheel housing access hole. Mate transmission (100) to engine (101). 5. Apply loctite to eleven screws (124). Install screws and torque to 35 45 ft-lbs (47 60 Nm). Remove lifting chains from transmission. 6. Apply loctite to screws (102, 103). Install screw (102) into bottom hole of right transmission mount. Install screw (103) into left hole of left transmission mount. 3-21