| |
TM 10-3930-664-24
Section II. SERVICE UPON RECEIPT
2-4.
SERVICE UPON RECEIPT.
a.
Remove any plastic tape, wrapping paper or any other shipping and protective items.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use
in a well ventilated area. Avoid contact with skin, eyes, and clothes and do not breathe vapors.
Do not use near open flame or excessive heat. The flash point is +100 to 138°F (+38 to 50°C). If
you become dizzy while using the solvent, get fresh air immediately and get medical aid. If
contact with eyes is made, wash your eyes with water and get medical aid immediately.
b.
Clean any exposed metal parts coated with rust preventive compound. Remove compound with cleaning
solvent (P-D-680).
c.
Inspect the forklift for damage incurred during shipping. If the unit has been damaged, report the damage on
DD Form 6, Packaging Improvement Report.
d.
Check the forklift against the packing slip to ensure that the shipment is complete. Report all discrepancies
in accordance with the instructions of DA PAM 738-750.
e.
Check all tags and forms accompanying the forklift for special instructions. Do not remove any forms or tags
until unit is installed and ready for operation. When installed, remove forms and tags and forward to Quality Control (QC)
section office.
f.
Clean all exterior surfaces. Touch-up any paint scratches.
2-5.
PRELIMINARY SERVICING AND ADJUSTMENT OF EQUIPMENT.
a.
Perform the operator Preventive Maintenance Checks and Services (PMCS) contained in TO 10-3930-660-10.
b.
Perform the unit PMCS contained in Table 2-1.
c.
Lubricate all points as shown in the Lubrication Order (LO10-3930-664-12) regardless of interval.
d.
Schedule the next PMCS on DD Form 314, Preventive Maintenance Schedule and Record.
e.
Report all deficiencies on DA Form 2407 it the deficiencies appear to involve unsatisfactory design.
f.
Check that all decals and plates are on forklift.
g.
Make sure forklift is ready for operation; remove all warning tags.
2-2
|