TM 10-3930-664-24 4. RELEASE   SEAL   ON   OUTSIDE   OF   RIGHT   SIDE WINDOW    (18).     CAREFULLY     REMOVE     RIGHT SIDE  WINDOW  FROM  WINDOW FRAME (20). 5. IF  DAMAGED,  REMOVE  WINDOW  RUBBER  (19) FROM WINDOW FRAME (20). B.CLEANING Clean    windows    and    related    components    in accordance with paragraph 1-24. C.INSPECTION 1.Inspect   windows   for   cracks   or   holes.            Check   for chipped edges. 2.Inspect  window  rubber  for  cracking, deformation, or permanent set. D.INSTALLATION 1.IF WINDOW RUBBER (19) WAS REMOVED, INSTALL IN RIGHT SIDE WINDOW FRAME (20). 2.INSTALL   WINDOW   (18)   INTO   WINDOW   RUBBER (19).    RESEAL    RUBBER    ON    OUTSIDE    OF WINDOW USING URETHANE SEALANT. 3.INSTALL   REAR   WINDOW   (13)   AND   WINDSHIELD WIPER ARM (9). a. Install   window   rubber   (14)   onto   window (13), using care not to damage rubber. b. Install assembled window rubber (14) and window  (13)  into  two  bottom  hold-downs (17).    Tighten hold-downs. c. Install    two    top    hold-downs    (17)    using screws (15) and nuts (16). d. Install  nut  (11)  and  collar  (12)  onto  wiper motor (10). e. Install windshield wiper arm (9) onto wiper motor (10). 2-362