TM 10-3930-664-24 NOTE Place   drain   pan    beneath    fluid    hoses when  disconnecting.    Drain  hoses  into pan. NOTE All  oil  tubes  and  hose  ends  should  be covered   with   a   shop   towel   or   simular item to avoid contamination of fluids. 4. Remove    transmission    oil    dipstick    (12)    from sleeve   (13).      Remove   sleeve   from   right   side plate    by    removing    screw    (14),    spacer    (15), clamp (16), and nut (17). 5. Remove engine oil dipstick (18) from sleeve (19) by removing clamp (20). Remove hose clamp (22)   from   hood   assembly   frame   by   removing screw (21). 6. Disconnect    transmission    filler    hose    (23)    by loosening   hose   clamp   (24)   and   pulling   hose away from right side plate. 7. Tag  and  disconnect  hose  assemblies  (25,  26, 27,  28)  from  elbows  (29,  30).    Remove  elbows from  welded  pipe  fittings  only  if  replacement  is required. 8. Remove cap (31) from DCA plug (32).  Remove plug  from  right  side  plate  by  removing  screws (33), nuts (34), screw (35),  washer (36), and nut (37). 9. Tag  electrical  cables  (38,  39,  40)  and  wire  (44) located at rear of slave receptacle (41). Disconnect  cables  and  wire  from  receptacle  by removing screws (42, 43). 10. Tag and disconnect electrical wiring from rear of hourmeter (45). 11. right    side    plate    (46)    from    forklift    frame    by removing  screws  (47),  washers  (48),    nuts  (49) screw (50), washer (51), and nut (52). 2-351