TM 10-3930-664-24 A.  REMOVAL 1. Release hood assembly (2) by lifting handle (1). Open hood assembly. NOTE Enlist  the  help  of  an  assistant  to  hold hood and stabilize during removal. 2. Install sling through radiator cap access port and around front edge on top of hood.  Attach sling to hoist  and  take  up  slack.    Use  blocks  to  secure front of hood during component removal. 3. Remove  screws  (3),  washers  (4),  and  locknuts (5)  to  release  two  safety  lanyards  (6).    Discard locknuts. 4. Release  gas  springs  (9)  from  chassis  brackets by   removing      retainers      (10).      Secure      gas springs to inside of hood to prevent damage. 5. Detach  hood  assembly  (2)  from  forklift  chassis by removing screws (7) and locknuts (8). Discard locknuts. 6. If   required,   remove   studs   (11)   from   chassis brackets by removing nuts (12). 7. Lift hood assembly (2) from chassis and move to a     level     surface     for     cleaning     or     additional maintenance. B.  CLEANING Clean hood assembly and related components in accordance with paragraph 1-24. C.  INSPECTION Inspect hood and related components in accordance with paragraph 1-24. 2-343