| |
TM 10-3930-664-24
4.
Lubricate grease cavities of cross assembly (7)
with grease. Pack bearings (9) 1/4 full with
grease.
5.
Place
cross
assembly
(7)
into
slip
yoke
assembly (8). Grease fitting (11) must face
towards slip yoke.
6.
Position cross assembly (7) so that one end of
cross sticks out beyond outer surface of slip
yoke hole.
7.
Place first bearing (9) onto the exposed end of
cross assembly (7). Align bearing with hole in
slip yoke.
8.
Place slip yoke (8) in an arbor press. Place a
solid plug on bearing (9) and press into hole in
slip yoke.
9.
Install snap ring (10).
10.
Repeat steps 7 through 9 for remaining bearing.
2-281
|
