| |
TM 10-3930-664-24
NOTE
When performing the following test,
the backup alarm switch (installed in
Port C) must be removed to measure
the pressure at Port C and to attach
the gauge to Port M. Place the plug
removed from Port M into port C
during the forward clutch pressure
test.
7.
Connect pressure gauge to each port listed
below
and
record
each
oil
pressure.
Transmission
must
be
shifted
to
operate
corresponding clutch. Engine idle shall be 400
to 600 rpm.
a.
Port C = Reverse
b.
Port E = 2nd gear
c.
Port F = 3rd gear
d.
Port K = 1st gear
e.
Port M = Forward
8.
All clutch pressure readings must be within 5 psi
of each other. No reading may be less than 185
psi.
9.
Apply Loctite to threads of nine transmission
cover screws. Install top transmission cover
using screws and washers.
10.
Close hood assembly. Ensure handle is fully
engaged.
FOLLOW-ON MAINTENANCE:
Disconnect STE/ICE tester (para. 2-13)
Raise tow bar and lock in position (para.
2-126)
END OF TASK
2-267
|