TM 10-3930-664-24 3. REMOVE LAMPS (7, 8) AND LIGHT BAR (13) FROM PARKING LIGHT ASSEMBLY. a. Remove composite light lens (4) from light body (12) by removing three outer screws (5) and two interior screws (6). b. Carefully  remove  lamps  (7,  8)  from  light  body (12). c. Remove composite light face plate (9) from light body   (12)   by   removing   remaining   two   outer screws (10). d. Remove    packing    (11)   only   if replacement is required. e. Open  front  half  of  light  bar  (13)  from  rear  half (14) using a screwdriver. Remove light bar from light body (12) by turning internal screw (15). B. CLEANING Clean     parking     light     housings     and     lens     caps     in accordance with paragraph 1-24. C. INSPECTION Inspect  housings,  lens  caps,  and  related components in accordance with paragraph 1-24. D. INSTALLATION 1.  INSTALL LAMPS (7, 8) AND LIGHT  BAR  (13)  INTO PARKING LIGHT ASSEMBLY. a. Position light bar into light body (12) and secure by turning internal screw (15).  Snap front half of light bar (13) onto rear half (14). b. Install packing (11). c. Install  composite  light  face  plate  (9)  onto  light body (12) using two outer screws (10). d. Carefully install lamps (7, 8) into light body (12). e. Install  composite  light  lens  (4)  onto  light  body (12) using three outer screws (5) and two interior screws (6). 2-202