TM 10-3930-664-24 D.  INSTALLATION 1. INSTALL THERMOSTAT HOUSING (6) AND THERMOSTAT (9). a. Install  alternator    support    (12)  onto  thermostat housing (6) using screws (13). b. Install thermostat (11) into housing (6). c. Install new gasket (10) into housing (6), ensuring side of gasket with lip faces housing. d. Mate  lifting  bracket  (9)  to  housing  (6),  aligning mounting holes. e. Install        assembled    components    onto    engine block using two long screws (7) and short screw (8).      Short   screw   goes   into   bottom   mounting hole. 2. TORQUE SCREWS (7, 8) TO 18 FT-LBS (24 Nm). 3. LIFT    ALTERNATOR    (5)    INTO    POSITION    AND INSTALL MOUNTING SCREW (4). 4. POSITION     ALTERNATOR     (5)     FOR     CORRECT BELT ALIGNMENT.  TIGHTEN LINK SCREW (3). 5. TORQUE   SCREW   (3)   TO   18   FT-LBS   (24   Nm). TORQUE SCREW (4) TO 32 FT-LBS (43 Nm). 2-156