| |
TM 10-3930-664-24
2-44. ACCELERATOR ACTUATOR WITH PEDAL REPLACEMENT
This task covers: Removal, Cleaning, Inspection, and Installation
INITIAL SETUP:
Tools and Test Equipment:
Personnel Required:
General Mechanics Tool Kit (1, App. E)
2 Personnel
Drain Pan (10, App. E)
Materials / Parts:
Teflon Tape (35, App. C)
Brake Fluid (5, App. C)
A. REMOVAL
1.
DISCONNECT HOSES (1, 2) AND REMOVE
ACCELERATOR
ACTUATOR
ASSEMBLY
(3)
FROM FLOOR PLATE.
a.
Place drain pan beneath accelerator actuator
assembly (3).
b.
Disconnect hoses (1, 2) from elbow (7) and
actuator fitting. Cap hose ends.
NOTE
Observe pedal (9) and note which
mounting
hole
is
used
before
removing screw (10). This will aid in
reassembly.
c.
Remove screw (10) that secures rod end (11) to
pedal (9). Remove spacer (12).
d.
Remove accelerator actuator assembly (3) from
floor plate by removing screws (4), accelerator
stop (5), and nuts (6).
e.
Remove elbow (7) from accelerator actuator
assembly (3).
B. CLEANING
Clean accelerator actuator assembly in accordance
with paragraph 1-24.
2-141
|