TM 10-3930-664-24 C.  INSPECTION Inspect components in accordance with paragraph 1-24. D.  INSTALLATION 1. INSTALL BRACKET (7) AND MOUNT (12). INSTALL ACCELERATOR SLAVE CYLINDER (5). a. Install mount (12) to engine using screws (17). b. Secure  accelerator  slave  cylinder  (5)  to  bracket (7)  by  threading   cylinder   rod   into   bracket   and tightening nut (6) against bracket. c. Install  bracket  (7)  to  fuel  pump  control  lever  (8) using   shoulder   bolt   (9),   washer   (10),   and   nut (11). d. Install  elbow  (4)  into  accelerator  slave  cylinder (5). e. Secure  accelerator  slave  cylinder  (5)  to  mount (12) using screw (13), washers (14), nut (15) and locknut (16). 2. CONNECT HOSE (3) TO ELBOW (4). 3. ADJUST    THROTTLE    CONTROL    CYLINDER    IN ACCORDANCE WITH PARAGRAPH 2-42. NOTE Capacity  of  throttle  control  reservoir is   small.      Check      fluid      level      in reservoir  frequently  and  add  fluid  as necessary during bleeding process. 4. BLEED ACCELERATOR SLAVE CYLINDER. a. Depress  accelerator  pedal  and  open bleeder screw (18) to allow air to escape. b. Close   bleeder   screw   and   release   accelerator pedal. c. Repeat  steps  a.  and  b.  until  fluid flowing from bleeder screw is free of air. 2-139