TM 10-3930-664-24 D.   INSTALTATION 1.     APPLY   TEFLON   TAPE   TO   ALL   FUEL   FITTINGS BEFORE INSTALLATION. 2.    NSTALL   INJECTION   PUMP   SUPPLY   LINES   (12, 36, 40). a. Install  three  new  grommet  seals  (39)  onto  tee (38). b. Connect  injection  pump  supply  line  (12)  to  tee (38). c. Connect    supply    line    (40)    to    front    fitting    on injection pump (37). d. Connect supply lines (36, 40) to tee (38). e. Connect    supply    line    (36)    to    rear    fitting    on injection pump (37). 3.     TORQUE ALL SUPPLY LINE NUTS TO 24 FT-LBS (32 Nm). 4.     INSTALL FUEL DRAIN LINES (24, 27, 31). a. Install   three   new   grommet   seals   (26,   28,   32) onto tee (25). b. Connect drain lines (27, 31) to tee (25). c. Secure   drain   line   (27)   to   engine   block   using screw (29) and grommet seal (30). d. Connect drain line (24) to tee (25). 5.     TORQUE ALL FUEL DRAIN LINE NUTS TO 18 FT- LBS (24 Nm). 6.     TORQUE SCREW (29) TO 18 FT-LBS (24 Nm). 2-101