TM 10-3930-664-10 (5) Pull the LIFT and SIDESHIFT joystick to the rear to raise load to desired height for removal from stack or for transport. (6) Pull  the  TILT  and  ROTATE  joystick  to  the  rear  to  tilt  mast  rearward  enough  to  safely  transport  the  load without danger of the load sliding off the forks. d. Transporting a Load. WARNING Always operate the 4KRTFL at a safe speed.  Know the rated capacity of the 4KRTFL and do not overload it.    Avoid  sudden  stops  to  prevent  the  load  from  sliding  forward  and  off  the  forks.    NEVER  tilt  the  mast assembly forward beyond the vertical position except to deposit the load on a stack, trailer, or ground. (1) To clear a stack or exit a container, place travel and range select lever in R1 and use the service brake and inching pedal to Inch the 4KRTFL rearward. (2) With  load  tilted  rearward  and  lowered  to  normal  carry  height  of  12  inches  (30  cm)  above  the  ground, transport the load at a safe speed for the type of load and terrain. (3) As necessary to compensate for uneven loads or sloping terrain, move the TILT AND ROTATE joystick to the left or right to rotate forks to desired position. e. Depositing a Load. (1) Bring the mast assembly to a vertical position by pushing the TILT AND ROTATE joystick forward. (2) As necessary, align the forks with the stack, trailer, or ground by moving the TILT AND ROTATE joystick left or right to rotate the forks to the desired position. (3) As necessary, move the LIFT AND SIDESHIFT joystick left or right to shift the load left or right to place the load in the proper position for unloading. (4) If the load is to be placed on a stack or a level higher than the transport level, raise the fork to the desired height by pulling the LIFT AND SIDESHIFT joystick to the rear. (5) Use the service brake and inching pedal to inch the 4KRTFL forward to the location where the load is to be placed. (6) Push  the  LIFT  AND  SIDESHIFT  joystick  forward  to  lower  the  load  until  it  rests  on  the  stack,  trailer,  or ground. (7) Place  the  travel  and  range  selector  lever  in  the  R1  position  and  use  service  brake  and  inching  pedal  to back 4KRTFL away from the load. 2-38