| |
TM 10-3930-660-34
3-3.
ENGINE ASSEMBLY - REPLACE (Cont’d)
9.
INSTALL DRIVE SHAFT ASSEMBLY (1) TO ENGINE DAMPENER
(7).
a.
Position engine coupling (9) with shaft assembly (1) into engine
dampener (7).
b.
Apply Loctite 242 to three bolts (8) and secure coupling (9) to
engine with capscrews (8).Tighten capscrews to 25 lb. t.
10.
INSTALL DRIVE ASSEMBLY (1) TO TRANSMISSION (2).
Apply Loctite 242 to four capscrews (3).Secure universal joint (5) of
shaft assembly (1) to input yoke (6) of transmission (2) with four
capscrews (3) and four new lockwashers (4).Torque capscrews (3) to
41 lb. ft.
11.
TIE WRAP LINES AND ELECTRICAL WIRES AT AREAS NOTED DURING ENGINE REMOVAL, AND AS
NECESSARY TO PREVENT DAMAGE TO LINES AND WIRES.
12.
INSTALL MUFFLER, TM10-3930-660-20.
13.
SERVICE AIR CLEANER ELEMENTS,
TM10-3930-660-20.
14.
INSTALL AIR CLEANER,
TM10-3930-660-20.
15.
INSTALL RADIATOR, TM10-3930-660-20.
16.
SERVICE COOLING SYSTEM WITH COOLANT, TM10-3930-660-20.
17.
SERVICE ENGINE WITH ENGINE OIL, TM10-3930-660-20.
18.
CONNECT NEGATIVE BATTERY CABLE, TM10-3930-660-20.
19.
ADJUST ACCELERATOR CABLE, TM10-3930-660-20.
3-24
|
