| |
TM10-3930-660-34
16-21. PISTON PUMP - REPAIR (Contd)
DISASSEMBLY
NOTE
Clean outside surfaces of the valve
block and compensator before
disassembly.
1.
REMOVE COMPENSATOR (1).
a.
Remove four screws (2) and pull
compensator (1) from valve block
(3).
b.
Remove gasket (4) and O-ring (5)
from compensator (1). Discard
gasket and O-ring.
2.
REMOVE ROTATING GROUP PARTS FROM
HOUSING (6) AND VALVE BLOCK (3).
NOTE
Piston (7) will slide from rod piston
(8) and drop into the pump housing (6)
when valve block (3) is removed from
the pump housing (6).
a.
Remove six screws (9) and remove
valve block (3) from housing (6).
b.
Remove and discard gasket (10).
c.
Remove wafer plate (11) from
valve block (3).
d.
If necessary, remove pin (12)
from valve block (3).
e.
Remove bearing (13) and spacer
(14) from drive shaft (15).
NOTE
Three pins (16) will drop from the
cylinder block (17) when rotating group
parts (18) are removed from shaft (15).
16-129
|